wearban GEAR – permanent sliding coating for older gear boxes.
Long life to your vehicle!
wearban GETRIEBE plus Permanent sliding coating guarantees protection for older gearboxes/gearboxes with high mileage.
- Improves gear shifting
- Reduces oil temperature
- Reduces friction loss
- Lowers fuel consumption
- Smoother operation of gear and differential
- Significantly longer life for all parts sitting in oil
- High shear stability for extreme operation load
This makes the wearban coating so special:
wearban GEAR lines the friction surfaces with PTFE, the lowest-friction of all substances on the Earth. The surfaces glide against each other “like wet ice on wet ice” (Guinness Book of Records)
More details about the priciple of operation:Added to the gear oil, wearban GEAR circulates with the oil. Thereby the special formula accomplishes the cleansing of the surfaces: firstly, the metal pores are exposed. Secondly, the PTFE particles are drawn towards the pores by the electrostatic charge.
Heat and pressure make sure the particles settle inside the pores permanently. Die PTFE/metal compound is permanent and chemically neutral. Only very hard particles and dirt can lead to an erosion of the protective layer.
In normal operation, the layer lasts about 80000 to 100000 km (ca. 50000 – 62000 miles). wearban GEAR stays in the engine permanently.
wearban GEAR matches with any oil on the market.
Suitable protection for your gear type:
• for manual transmissions with up to 2.0 l of gear oil • for manual transmission with ATF Oil up to 2.0 l
For more types of transmission see out product wearban GETRIEBE
Application:
- Open refill srew
- Check if there is sufficient room for filling
- fill in wearban GEAR plus
- screw shut
- let motor run in neutral for 5 minutes, without shifting gears
Caution / Safety note
Harmful to aquatic organisms, may cause long-term adverse effects Wear protective gloves/protective clothing/eye protection/face protection Danger. Causes serious eye damage. In case of contact with eyes, rinse carefully with water for several minutes. Remove contact lenses, if present and easy to do. Continue to rinse. Immediately call a Poison Center or doctor/physician. If medical advice is needed, have product container or label at hand. Keep out of reach of children. Avoid release into the environment.
Wearban can not accept any liability for the correctness or completeness and can not be held responsible for damages of material or immaterial nature caused by the usage or non-usage of the information offered or the usage of incorrect or incomplete information. Users have to judge the applicability of the information and the products for their purpose for themselves. They must not suggest suitability based on contained or omitted information. All liability is excluded for damage based on wrong assumptions regarding the information or the usage thereof (including liability on the basis of negligence or cases in which the company Wearban was aware of potentially occurring damages.)
Dispose of the content/container by reason of local/national provision UFI: