New product development!

wearban SERVO, the permanent sliding coating of all parts in the power assisted steering system

This makes the wearban coating so special:

wearban SERVO lines the friction surfaces with PTFE, the lowest-friction of all substances on the Earth. The surfaces glide against each other “like wet ice on wet ice” (Guinness Book of Records).

More details about the principle of operation:

Added to the servo-oil, wearban SERVO circulates with the oil. Firstly, the special formulation achieves the cleaning of the friction surfaces: The metal pores are exposed. Secondly, the PTFE particles are attracted to and implanted in the pores because of the electrostatic charge.  

Heat and pressure make sure the particles settle inside the pores permanently.

The PTFE/metal compound is permanent and chemically neutral. Only very hard particles and dirt can lead to an erosion of the protective layer. With normal use the layer lasts for ca. 80.000 to 100.000 km.

wearban SERVO permanent sliding coating matches with any oil on the market (except from plant oils that aren’t immiscible with other oils.)

Suitable protection for your steering assist system

wearban SERVO permanent sliding coating is suitable for all types of power steering assist systems with oil.

• for SAS with up to 1.0 l of oil
• for SAS with up to 2.0 l of oil
• for SAS with up to 4.0 l of oil

If your SAS requires more than 4.0 l, please contact us for an individual fill.

Application:

1. Open lid of SAS filler
2. Check if there ist enough room for the additon of wearban SERVO. If neccessary, suction some oil.
3. Knead the bag for thoroughly mixing the content (ca. 2 min)
4. fill in wearban SERVO
5. close lid

Caution / Safety note

Harmful to aquatic organisms, may cause long-term adverse effects Wear protective gloves/protective clothing/eye protection/face protection Danger. Hazardous for the environment. Keep out of reach of children. Causes serious eye damage. In case of contact with eyes, rinse carefully with water for several minutes. Remove contact lenses, if present and easy to do. Continue to rinse. Immediately call a Poison Center or doctor/physician. If medical advice is needed, have product container or label at hand.

Avoid release into the environment.

Wearban can not accept any liability for the correctness or completeness and can not be held responsible for damages of material or immaterial nature caused by the usage or non-usage of the information offered or the usage of incorrect or incomplete information. Users have to judge the applicability of the information and the products for their purpose for themselves. They must not suggest suitability based on contained or omitted information. All liability is excluded for damage based on wrong assumptions regarding the information or the usage thereof (including liability on the basis of negligence or cases in which the company Wearban was aware of potentially occurring damages.)

Dispose of the content/container by reason of local/national provision
UFI:

Caution / Safety note